Training Videos Associated with HinksPix Controllers

From the Controller’s Menu Capability – how to return the Controller back to a virgin state – back to Factory Default Settings

From the Controller’s Menu Capability – How to set your correct “Time Zone” and if Daylight Savings should be active.

Default Timezone is Central USA

From the Controller’s Menu Capability – How to set which MODE of Operation the controller will operate in: E131, Master, Slave.

E131:  In this mode, the controller will listen to an Ethernet connection for E131, ArcNet, or DP messages and display the Lighting content contained with.

Master:  In this mode, the controller is operating in “StandAlone” mode and is acquiring its Lighting and Audio data from the on-board SD card. 

There can ONLY be ONE Master Controller in your display since THAT controller will have all Slave controllers synchronize operations with its own.

Slave:  In this mode, the controller is operating in “StandAlone” mode and is acquiring its Lighting and Audio data from the on-board SD card.  The Slave Controller takes all PLAY direction from the Master controller via a “Wired” Ethernet connection or a WIFI connection

A Static IP can be set from the Controller’s Web Server or from the Controller’s Menu Capability.

This video is how to set a Static IP from the Menu System

Your Display’s Lights / Pixels can be tested from the Controller’s Web Server or on “Start-UP”.

This video is on how to test your lights when the Controller starts after turning on Power.

Close Menu